GT Slim Battery Casing

Please check the home page to understand the batch shipping system before making your order 

Kit comes fully constructed with:

• A machined lid of selected colour
• A black composite plastic casing
• Soft lid gasket
• A breathe patch
• All Bolts 
• A clear LED window
• Battery cable gland
  
• A sheet of 2mm adhesive foam, and 1mm adhesive foam

This casing is designed for the tail of the a GT Build, housing a 21700 based battery. It's intended to complement a normal GT Controller casing or a GT Sym casing for use of the Slim GT Mushies.

This casing fits and 18s2p 21700 battery with lots of excess room. Make sure to accurately measure the battery thickness and use the right amount of foam to offset the internal height of 43.25mm.

The casing can fit a 20s2p 21700 pack build in a stacked configuration (built square, not angled) but only when the pack has been built efficiently with properly sized 21700 cells (not >21.1mm dia)

This casing is designed to fit stock GT rails and GT WTF rails from The Float Life. 
Tech-Rail's have had fitment failures due to tighter internal geometry.

• Gasket Details:
  The gasket fits into a machined groove in the lid allowing for a tighter tolerance, reducing the wall width across the entire design and increasing internal volume.
• Bolt Details:
  The Bolts are designed to be as long as possible in different sections of the casing to compress as much plastic as possible, increasing strength. The Bolts are M3 sized near the LED window and M4 sized elsewhere.
• Printing details:
  The casings compositely-printed with tough TPU68D in thicker sections for increased toughness, and PPA-CF in thin, flat sections for rigidity. 
  Every outside face of the casing is TPU68D, making an environment-exposing shatter extremely unlikely.
  
• Fitment details:
  The internal height is 43.25mm and attention must be made to match the thickness of your battery, plus the thickness of the utilised foam, to this free height.